Comment on Clever trick to Un tangle a spool
finalarbiter@lemmy.dbzer0.com 3 weeks agoHonestly idk. It’s happened to me before, but not in the last several years. I know it wasn’t my fault because the tangles were deep in the spool and only uncovered late in a print, so it’s unlikely to have been caused by user error during handling or filament loading.
B0rax@feddit.org 3 weeks ago
And even more unlikely to happen during production. Think about it, how would that work? Lift up the filament extruder, take out the spool, run around the extruder and continue after that?just to tangle the filament?
otter@lemmy.dbzer0.com 3 weeks ago
That’s not how logic works. When’s the last time you’ve seen that specific manufacturing workflow? Citation needed.
finalarbiter@lemmy.dbzer0.com 3 weeks ago
It’s really easy to make a clove hitch- One loop basically just needs to slide under another. It isn’t difficult to imagine that the machine could have a little bit of play or backlash that could affect the ends of each layer in this manner.