FuglyDuck@lemmy.world 5 days ago
an MEK vapor bath would likely give you a smooth finish. But, Uhm, personally the raw print is probably preferable as MEK is some nasty shit. (not so nasty you can’t buy it at your local big box hardware store, but it’s not something you can just pour into a kitchen pot and be safe around.)
Soooo I did actually try Vapor Smoothing with MEK Before! Infact I still got a Litre of that Stuff Around now, but even after leaving the print in there for Days at 50°C the Results where… honestly no big Changes at all…
I do suspect there is an Error in my Methodology… but turns out there isnt a lot of Info out there on Vapor Smoothing with MEK… Have you used MEK for Vapor Smoothing before?
I’ve not used MEK personally, all of my petg parts are structural. What I’m seeing online says 60-80c.
What I’d do is kick it up by 5c and swap in failed test prints and see how that changes things. Maybe also “priming” the chamber with a heat gun so the air is also warm. (Do this before placing the MEK!)
The main thing I’m wondering right now, is the MEK supposed to Boil? I feel like it should be, but at that point im also working with e Pressurised Vessel with very much Dangerous chemicals… thought’s?
i;ve never used pressurized vapor baths, for anything. I’d certainly stay away from pressurized vapor baths using heated solvents that are also rather flammable (that’s… got some exciting possibilities that I would let my worst enemy do first.) I’d use picture glass (or cheap ikea mirrors.) to build up a box. set it up outside where the vapors aren’t a problem.
alternatively, a cheap-ass-fuck stock pot with a glass lid will also work fine, but don’t seal it… and certainly don’t use it for food when you’re done.
as for if it should boil, it’s boinling point is about 80 deg. C, so if you’re seeing boiling, you either have somewhat impure MEK (which is fine,) or your temp measurement is off. It should still put enough vapor into the box that you can see it working though… it’ll just work faster.
I habe never used mek, but acetone on abs. Works like a charm.
SaveTheTuaHawk@lemmy.ca 4 days ago
don’t work with MEK unless you have industrial venting.