Comment on Any tips for printing 85A TPU on bambulab A1?

• DarkCloud@lemmy.world ⁨2⁩ ⁨months⁩ ago

  After that the next step is usually to do a test print where you increase temperatures until you’re at the maximum range for the filament.

  Basically you’re searching for the sweet spot (heat is a major variable because it also affects flow).

  source

  • Wizard_Pope@lemmy.world ⁨2⁩ ⁨months⁩ ago

    I tried 235-250° without much change. Even tried uping the flow rate to 1.2 in the preset.

    Image

    This is the only attempt that did not just fail at like layer 10 or something. And it’s still bad.

    source