Comment on Any tips for printing 85A TPU on bambulab A1?
Sphks@jlai.lu 1 week ago
Is your filament dry? With TPU, it’s the first time that I saw a drastic difference of print quality. I dry my TPU for 3 hours at 45°C each time before printing.
Comment on Any tips for printing 85A TPU on bambulab A1?
Sphks@jlai.lu 1 week ago
Is your filament dry? With TPU, it’s the first time that I saw a drastic difference of print quality. I dry my TPU for 3 hours at 45°C each time before printing.
Wizard_Pope@lemmy.world 1 week ago
I dried it for 8 hours before printing
DarkCloud@lemmy.world 1 week ago
After that the next step is usually to do a test print where you increase temperatures until you’re at the maximum range for the filament.
Basically you’re searching for the sweet spot (heat is a major variable because it also affects flow).
Wizard_Pope@lemmy.world 1 week ago
I tried 235-250° without much change. Even tried uping the flow rate to 1.2 in the preset.
Image
This is the only attempt that did not just fail at like layer 10 or something. And it’s still bad.