multiple toolhead printers still use a purge tower which is waste.
Comment on Bambu Regrets
Rhaedas@fedia.io 12 hours agoThanks for the mention. I'm not into 3D printing yet, but had looked around to get familiar with things and was going to settle for a single color type since the whole poop thing seems ridiculous if you can't easily capture that waste back. Looking at this one, it makes sense to spend a bit more to get multiple heads to do different colors and material at once. Imagine if color printing on paper had you spit out a bunch of one color into the trash to switch to a new one.
SaveTheTuaHawk@lemmy.ca 11 hours ago
CIA_chatbot@lemmy.world 10 hours ago
I usually purge into the fill and support, and the poop is almost non-existent
CmdrShepard49@sh.itjust.works 8 hours ago
Its not as bad as you think especially when you’re comparing them to lower quality printers that cause you to throw a bunch of half finished prints in the trash due to print errors. You can also avoid this if you use/make models that have the colored parts split out so you’re only printing one color at a time, or minimize waste by printing multiples of whatever multicolored object you’re printing. The waste is the same whether you’re printing 1 or 50.
Some prints its unavoidable, but I certainly feel like I’ve wasted way less plastic with my Bambu printers than I did with the bed slinger I had before it.
Multiple toolheads are probably the better way to go but these introduce their own issues and can lead to print failures as well since they’re way more complex than a single toolhead.