Comment on Bubbles in molten filament?
Kratzkopf@discuss.tchncs.de 5 days agoThanks very much, that is also good input! I think there is quite some room for the heat sink to be badly aligned, as the heating element can wriggle a bit down and up and is not super firmly fixed. This was a parameter I had not yet considered. Is there in your experience more clogging if the heat sink overlap is too small or too big? I consider adding a bit of heat conducting pate to improve cooling.
I misunderstood you at first and thought of the gap between nozzle and heater, which might also be a problem with the internal screw in my setup. So I gave it in another clean and have hope that the nozzle is better heated through now. Image
autriyo@feddit.org 4 days ago
Gap looks big enough. I don’t think you can really have too big, at least without modifying.