Comment on Bubbles in molten filament?
autriyo@feddit.org 1 week ago
I don’t know how your hot end is constructed, but on the cheap e3d clones its easy to accidentally undo the gap(heatbreak) between the heating block and the heatsink while changing nozzles.
Especially when dealing with clogged/stuck stuff. I’ve been chasing clogging issues on mine for a while, which eventually turned into failure to heat problems.
And only after ruling out nearly everything else did I notice that the gap/heatbreak was not there anymore. Which is constrained only by screwing things together the right amount, when fighting with clogs constantly, its kinda easy to lessen that gap slightly every time.
Kratzkopf@discuss.tchncs.de 5 days ago
Thanks very much, that is also good input! I think there is quite some room for the heat sink to be badly aligned, as the heating element can wriggle a bit down and up and is not super firmly fixed. This was a parameter I had not yet considered. Is there in your experience more clogging if the heat sink overlap is too small or too big? I consider adding a bit of heat conducting pate to improve cooling.
I misunderstood you at first and thought of the gap between nozzle and heater, which might also be a problem with the internal screw in my setup. So I gave it in another clean and have hope that the nozzle is better heated through now. Image
autriyo@feddit.org 4 days ago
Gap looks big enough. I don’t think you can really have too big, at least without modifying.