The Anycubic has presets for .4 and .6 in brass or hardened steel. It’s only missing .2.

I couldn’t care less. Drying is done in an oven.

You can’t claim the S1 is incomplete for not having a .2 nozzle presets and then turn around and say that a built in filament dryer doesn’t matter when Bambu made it a pro feature. Especially when .4 is what you get out of the box from Bambu and .2 requires modifying your printer by swapping the hot end.

Bought the P1S combo (AMS 1) for 636

Where? I see 800€ everywhere.

And where I go after Bambu is what you didn’t mention: locked down firmware and no alternative slicer.