I’ve tweaked the line width a lot, going down to .175 but not lower. It didn’t seem to make a difference. I did try to add another junk model next to the caps just to offset the heat; it unfortunately didn’t help. Which settings are you looking at with pressure advance; the main thing I have been touching is flow rate.
Comment on Stumped - Improving fine detail prints with a .2mm nozzle?
ButteredWaffle_@reddthat.com 1 day ago
Hiya, my 2 cents. If you have a well tuned machine (which i assume you do):
- Extrusion widths that are up to 50% larger than your nozzle diameter are beneficial, because the brim of your nozzle flattens the material against the lower layer
- Printing many keycaps at once can help the stem cool completely between layers, if heat is a problem
- Have you tuned pressure advance after swapping nozzles?
surfrock66@lemmy.world 1 day ago
IMALlama@lemmy.world 1 day ago
It always amused me that some slicers that allow for percentage based extrusion widths use layer height, and not nozzle diameter when applying that value…