Comment on cannot get an even first layer with a voron trident
VinS@sh.itjust.works 2 weeks ago
You have a lot of possible options here.
- Your bed is ok, mine is 0.6 variation (sad I know)
- dish soap with no additives, rinse and dry it correctly before installing it back
- Verify that it’s doing this in the good order :
- Pre-heat bed
- Home XYZ
- Bed leveling
- Re home Z
- Bed Mesh
- Start print
If everything is ok, as someone else said, it’s maybe a X twist.
muusemuuse@lemm.ee 2 weeks ago
I have reworked the start_print gcode macro to incorporate a heat soak before scanning for a mesh. While its running that 20 minute soak, I notice that the temperature reading on the beacon coil is actual dropping while everything else is increasing during the soak. Is just above the bed, in the center, doors closed, and its readings are getting steadily lower. What could possibly cause that?
VinS@sh.itjust.works 2 weeks ago
Heat soak should not change what you have here. During the heat soak, machine expands a little. You will get a more usefull Z / mesh when the machine gets to equilibrium.
If you still have problems after that, it’s probably a X twisted, see the linked document above. Unfortunately I do not have much time to dig into your configs.