I second this. I’ve had far more issues printing small parts than large due to printing too fast. I like to use minimum layer time, but max flow rate works too.
Comment on An interesting issue
MxRemy@piefed.social 1 month ago
Maybe something to do with your max volumetric flow rate? Could cap that lower and see if anything changes with the 0.4mm
GrayBackgroundMusic@lemmy.zip 1 month ago
Bluewing@lemmy.world 1 month ago
Been there done that. Didn’t work. It did print the calibration print just fine. It just sucks when I try and print these gears.