Comment on Septic clean out cap
GhostlyPixel@lemmy.world 6 days agoAre your PLA+ prints taking any load at all? I have some PLA+ pieces that I have printed to repair outdoor Halloween and Christmas decorations which are at some stress points in the decorations and I have to replace them at the start of each season because they get so brittle by the time the holidays are over.
IMALlama@lemmy.world 6 days ago
They’re under an intermittent load, but it’s probably not very high. Interestingly, the parts don’t seem very brittle. I suspect the exact materials in PLA+ probably vary wildly between blends/companies, so their material properties likely have some variation.