Comment

Comment on I found a way to keep my chamber temps up for long/big ASA prints

Dkarma@lemmy.world ⁨1⁩ ⁨month⁩ ago

What the holy hell is this nonsense?

You guys will do anything to keep from buying a good printer won’t you?

I’ve done 21 hours prints in my damp cold basement without issue.

You guys make me feel so competent haha.

Sort:hotnew top

j4n3z@lemm.ee ⁨1⁩ ⁨month⁩ ago
Imagine feeling so confident to indirectly call Voron a bad printer and tell people how to spend money.

Go get yoursel something to work on instead of mocking other for their temporary solutions.

source
IMALlama@lemmy.world ⁨1⁩ ⁨month⁩ ago
ASA and ABS are warp prone and this is an 11" / ~275mm wide print that’s equally tall 🤷

The build volume of my printer means lots of surface area for the acrylic enclosure, which in turn makes it hard for me to exceed a 50°C chamber temp, despite 4x bed fans.

The next print, with normal supports, pulled the bed off the magnetic build plate. Insulation eliminated warping and let me pull off the print.

I do agree that a “nicer” enclosure is the preferred method. I have zero issues with PETG at this size. I’ve never tried PLA on this printer, but it should be fine too.

source