You could use XT60 connectors and connect together the ground pins
Comment on 5 pin connector recommendations that have both male and female sockets available
UndercoverUlrikHD@programming.dev 1 month agoI don’t know how aging affects the LED power draw, according to the manufacturer I shouldn’t expect more than 7.5A. When measuring peak power output, I get only get ~6A total though.
4 pins are for earth with each (measured) having ~1.5A going through them at peak brightness. The fifth pin must bear the total load of the four other pins.
Having 5 pins is of course not a strict requirement, it’s just the LED strip that has 5 connections.
jjagaimo@lemmy.ca 1 month ago
UndercoverUlrikHD@programming.dev 1 month ago
Sorry, my original comment was poorly written. While they do lead to earth, there is a mosfet in between each that receives a unique PWM signal. See the edit for more details.
jjagaimo@lemmy.ca 1 month ago
You could use something like a dsub connector with larger current carrying pins (more expensive) or a more regular connector (e.g. 15 pin dsub) with multiple pins for supply/high current.
Regular rectangular headers can handle anywhere from 1-5A so you might be able to get away with a 2x4 rectangular header (maybe a few more pins in parallel for everything just for insurance)
TonyTonyChopper@mander.xyz 1 month ago
If you solder together the ends on the LED you’ll only need 2 pins
UndercoverUlrikHD@programming.dev 1 month ago
By soldering the ends of the LED, do you mean the 4 earth connections? I should probably have clarified that the 4 “earth” connection only lead to earth when the mosfets connected to the LED is open. Each connection leading to earth is for either, R, G, B or W so they can’t be soldered together.