marci

@marci@sh.itjust.works

This is a remote user, information on this page may be incomplete. View at Source ↗

⁨Comment⁩ on ⁨Trouble keeping a top-heavy TPE part on the bed⁩ ⁨⁨1⁩ ⁨week⁩ ago⁩:
If you have a PEI sheet, try glue stick on the PEI sheet to print. The glue stick acts as a leveraging agent after printing, you can wash it off with warm water - otherwise the flexibles tend to stick too good and ruin the built plate. I use this method on my prusa mini for TPU where I had similar issues. Sticking flexible filament on the textured sheet can be hard, I had success by printing the brim layer in PLA in the past - but that was still on a Makerbot Mk2 which didn’t even have a heated bed.