Cross posted from: pawb.social/post/50725291
Is this blower a reasonable replacement for an Mk3s+?
Submitted 10 hours ago by cadekat@pawb.social to 3dprinting@lemmy.world
Submitted 10 hours ago by cadekat@pawb.social to 3dprinting@lemmy.world
Cross posted from: pawb.social/post/50725291
morbidcactus@lemmy.ca 57 minutes ago
I wish Prusa had the specs for the OEM part…
I’m almost certain I had a cheap 5v fan on my mk3s for a while after the fan killed itself (saw others complaining online about the wires breaking off at the solder pads really easily) which quick check online seem to range 2.7->3.5 cfm so flow rate wise I don’t think it’ll be a problem.