I want to replace one half of this with longer wire, but I am not confident about the name of the connector used.
Image of JST-XH included to convey size. Ruler is metric.
micro jst 1.25 ?
What is this connector called?
Submitted 11 months ago by waz@lemmy.world to askelectronics@discuss.tchncs.de
Comments
Fiivemacs@lemmy.ca 11 months ago
waz@lemmy.world 11 months ago
That was one of the two I found in my search. The other was Molex PicoBlade. None of the pictures I saw of gave me confidence either way.
Heir_Of_Isildur@lemmy.world 11 months ago
www.jst.com/products/category/wire-to-wire/
Probably good to check these out, maybe the XA series?
lnxtx@feddit.nl 11 months ago
Molex 51021 or similar. Could you measure the pin pitch?
gazter@aussie.zone 11 months ago
Your 2nd best bet would be to get the pin spacing, and filter your search using that.
Your first best bet would be to just replace both ends.
I settled on a ‘standard’ and just bought a massive kit of each of those connector types- wire-wire, wire-board, wire-panel in M and F, in various pole counts. Buy once, cry once.
Iamsqueegee@sh.itjust.works 11 months ago
A 2-pin connector?
waz@lemmy.world 11 months ago
Yes, 2 pins.
Adramis@lemmy.blahaj.zone 11 months ago
I think they’re saying that’s generally what it’s called.
hardaysknight@lemmy.world 11 months ago
Why not just splice the wire?
Eheran@lemmy.world 11 months ago
This is by far the best option for awkward connectors. You could even remove the pins and put the new cables in by opening the crimp and soldering the new ones without any splice.
RobotToaster@mander.xyz 11 months ago
This isn’t an easy question mattmillman.com/…/common-jst-connector-types/