Don't forget to change your z offset after swapping nozzles

Comments

• swordsmanluke@programming.dev ⁨1⁩ ⁨year⁩ ago

  Thankfully, It’s okay. Ish.

  My prints want to unstick a bit there, but overall it’s still working! The poor thing.

  source
• RegalPotoo@lemmy.world ⁨1⁩ ⁨year⁩ ago

  Rip

  source
• scotticus42@lemmy.nz ⁨1⁩ ⁨year⁩ ago

  Did that this morning. Except for I didn’t hit save and restart after setting new offset in klipper. But I just got a small scratch. I got lucky it wasn’t too bad. Lol

  source
• LazaroFilm@lemmy.world ⁨1⁩ ⁨year⁩ ago

  I don’t have this problem. I have a precision piezo Orion probe. My probe is my nozzle.

  source

  • skilltheamps@feddit.de ⁨1⁩ ⁨year⁩ ago

    How do you handle residual filament on the nozzle from previous prints? Or if you heat it up to get to nozzle itself to touch the bed, do you get dabs of plastic distributed around your bed?

    source

    • IMALlama@lemmy.world ⁨1⁩ ⁨year⁩ ago

      My probe hits my z endstop, so similar idea. I preheat my probe and manually wipe it before I home. Any ooze doesn’t really make a difference in first layer. At some point I’ll print a purge bucket and nozzle brush…

      My endstop is just a metal rod, but since it’s cold filament doesn’t stick to it. If I were probing my bed I would probably want a hot nozzle and cold bed.

      source
    • LazaroFilm@lemmy.world ⁨1⁩ ⁨year⁩ ago

      I preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush) without oozing. Then I do a 10mm retract before probing.

      source
• atocci@kbin.social ⁨1⁩ ⁨year⁩ ago

  Looks like my own Anycubic's base ❤

  source
• Sphks@lemmy.dbzer0.com ⁨1⁩ ⁨year⁩ ago

  Ouch

  source