The test prints in the image use the 0.2mm detail mode and 0.07mm ultradetail mode
I recently got a SV06, my first 3D printer, about a month and a half ago. About a week ago I started to find really bad oozing/ stringing on all of my prints, to the point that any functional prints are basically unusable. So far what I have tried is:
- Cleaning the nozzle, inside and out, using a damp cloth and the metal needle tool that came with the printer.
- Drying the filament. I had two rolls that I was using for the current print, so I used a DIY Dryer to dry both rolls, each on 70 degrees celcius for 4+ hours.
Neither of these have worked. What should I do next?
fhein@lemmy.world 2 months ago
What filament and other slicer settings? Could be too hot. Could be retraction settings. Did the oozing start when you switched nozzles? If it’s a cheap Amazon nozzle it might be faulty and have a different diameter than advertised. Did you follow the correct procedure with hot tightening when switching nozzles? If not, you might have got molten filament in between the nozzle and the heat break.
Interstellar_1@lemmy.blahaj.zone 2 months ago
Here’s the filament temperature range:
Filament settings: Image
Retraction settings: Image
I have not switched nozzles. (Am I supposed to?)
Thanks.