Comment on I should have checked this a long time ago...
fhein@lemmy.world 10 months ago
A lot of printers also heat the bed unevenly, so the temperature could be significantly higher in the centre of the build plate. This video shows it fairly well. You could try adding a few minutes delay to your start gcode after the printer thinks it’s reached the correct bed temp, to let it even out a little.
PipedLinkBot@feddit.rocks [bot] 10 months ago
Here is an alternative Piped link(s): piped.video/watch?v=yPy0zDpmc5U
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source, check me out at GitHub.