I believe the fact that it comes up as a “slot” is positive. SATA m.2 connectors don’t show up under slots, they come under “connector"s with type SATA.
Comment on Can the M.2 slot in my Dell Optiplex 3070 micro be used for ethernet? I don’t
djdarren@piefed.social 3 days ago This is the output of dmidecode
Handle 0x0026, DMI type 9, 17 bytes System Slot Information Designation: SLOT1_M.2 Type: x4 M.2 Socket 3 Current Usage: Available Length: Long Characteristics: 3.3 V is provided PME signal is supported Bus Address: 0000:ff:1f.7
Handle 0x0027, DMI type 9, 17 bytes System Slot Information Designation: SLOT2_M.2 Type: x1 M.2 Socket 1-SD Current Usage: In Use Length: Short Characteristics: 3.3 V is provided PME signal is supported Bus Address: 0000:ff:00.0
I’m guessing the top one is the M.2 in question, on account of it saying “Available”. And from what I understand having searched for some of the info on that, it should work, assuming the firmware allows for it.
toebert@piefed.social 3 days ago
Wildmimic@anarchist.nexus 3 days ago
The slot that is currently in use is the slower one since it’s only Type: x1. Depending on what you use the slot currently (such as an M.2 drive), you might wanna switch slots so you can take advantage of the M.2 speed; the x1 slot is completely adequate for 1gbps ethernet if you don’t need more. Both slots are otherwise functionally the same, but make sure to look up in your mainboard documentation if there’s any limitation if you use both slots or a specific hardware configuration (mine deactivated the second M.2 slot after changing from an 2600x to an 5950x for example)