Comment

Comment on OrcaSlicer V2.1.0 Official Release

The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.

source

Sort:hotnew top

GrayBackgroundMusic@lemm.ee ⁨5⁩ ⁨months⁩ ago

The UI of Prusa slicer is hot garbage though.

I’m comparing cura and prusa, so prusa wins by a lot. What are you comparing prusa to? Orca?

source
- Grippler@feddit.dk ⁨5⁩ ⁨months⁩ ago
  Yes
  
  source
u_tamtam@programming.dev ⁨4⁩ ⁨months⁩ ago

The UI of Prusa slicer is hot garbage though.

I give orca/bambu the edge for “prettier on screenshots”, but in practice, I don’t find their UI paradigm to be more efficient nor convenient.

source
- Grippler@feddit.dk ⁨4⁩ ⁨months⁩ ago
  In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.
  
  source