Comment

Comment on [Troubleshooting] Big stringing problem with flsun SR and Orcaslicer

I know esun is quite popular, but I never tried it.

I’ve generally had the best results with it. Ironically, before the upgrades I had almost no stringing.

I’m using a 0.4mm nozzle. I probably should have mentioned in the OP that I didn’t have problems before, but the upgrades have happened in addition to moving to Orcaslicer.

Now I’m worried if I’ve got my Bowden tube seated in the hotend correctly…

source

Sort:hotnew top

rambos@lemm.ee ⁨7⁩ ⁨months⁩ ago
Now I’m worried if I’ve got my Bowden tube seated in the hotend correctly…

Just pull/push the tube with your hands. If there is no play you are good, but if there is:

Inspect the bowden tube ends and cut them if they are worn out

Push the bowden tube in the fitting.

While pushing it in, press the collet down

Then pull it out with a nail and then zip tie it

I found original clips too thin, zip ties are much better IMO. It helped me remove stringing completely while using half of the retraction distance (using 0.6 nozzle)
source