Comment on Chonky nozzel + decent amount of material = opportunity for lots of spaghetti
IMALlama@lemmy.world 8 months agoI’ve had a few smaller prints go off without any problems, but could always give something a little taller a go just to be safe.
FuglyDuck@lemmy.world 8 months ago
It could be layer adhesion being hampered by bed temp. What are you printing in? Does it have a lot of warping at the corners?
IMALlama@lemmy.world 8 months ago
I think I found what was happening. Z hop was off and as the nozzle traveled at warp speeds over the print it was touching the prior layer ever so slightly. I think it snagged the infill in this print. Trying again with a hotter extruder and z-hop on.
It’s printing in an acrylic enclosed Voron 2.4. Zero warping.