Comment on [Troubleshooting] It's the clog guy again - temp readings are bad!
Damage@feddit.it 6 months agoYou could also have a thermistor with a connector on the wire near the toolhead, even if you don’t have a toolboard. Old E3D thermistors had only about 15cm of wire attached to them.
papalonian@lemmy.world 6 months ago
I’m not sure what you mean. Where does this 15cm of wire go to, if not a control board or simply a wire extension that runs to the main motherboard?
Damage@feddit.it 6 months ago
To an extension exactly. That’s why the other poster was suggesting to check the wiring, because it’s a common setup.