Comment on [Troubleshooting] It's the clog guy again - temp readings are bad!
bitfucker@programming.dev 5 months ago
I didn’t follow the saga but, have you tried reflashing the firmware and reinstalling klipper? Also, where did you run klipper from? Did you have a spare sbc to test on? Some incorrect software behaviour could also be a result of hardware failure or malfunction that wasn’t really visible.
papalonian@lemmy.world 5 months ago
I actually did just try reflashing Klipper to the board yesterday and it didn’t do anything, I haven’t updated Klipper on my Pi in a little while, but I can give it a go when I get home tonight. I do have a spare Pi, but it’s kind of a pain in the ass to rebuild everything on a new system for a high likelihood of not much changing
bitfucker@programming.dev 5 months ago
Yeah, sometimes computer can act normal (boot and everything) but the system has somehow become unstable. Sometimes that means there is improper hardware installation, or in embedded system, something is nearing its end of life due to defect or other myriad of factor.