No I did not change plates. I’ve been using the included plate without issue … until now!
Comment on PETG damaged plate
Atropos@lemmy.world 3 days agoI guess this may indeed be a z issue, those diagonal lines could be when the nozzle moved from corner to corner without laying material down.
I don’t think this has anything to do with the material or temperature or anything like that.
I’m not overly familiar with the Ender, but maybe run a bed levelling protocol or other calibration option? The plate is probably toast unfortunately.
user_6282638282@sopuli.xyz 3 days ago
user_6282638282@sopuli.xyz 3 days ago
Thanks for confirming… luckily these plates are double-sided so I have a backup while I order a replacement. As I mentioned in another post, the auto-leveling leaves the nozzle just a bit too high and so I’ve consistently had to lower it. I primarily print in PLA and so usually do my bed-leveling prints in that material. I’ve previously used PET-G with zero issues, so something about the sequence of leveling and adjusting must be different this time around.
Now I know to run the leveling each material change, which is annoying but probably not too surprising.