Comment on [Troubleshooting] Cannot fix a clogging issue.
rambos@lemm.ee 6 months agoI’ve read your update in OP, how did it clog in the heat break? Do you have a picture? Can you run the same test without heat break, just extrude cold filament in the air (no bowden tube). That test would show if your extruder is working properly. I still think you might have stepper driver or motor overheating. If the test doesn’t fail it would mean you should look into bowden tube/heat break
papalonian@lemmy.world 6 months ago
I repeated the test I attempted after clearing the clog (heat block detached, heat break and Bowden tube still attached) with 1000mm of filament through the cold heat break and it went fine. I’ve updated the post again; strongly suspecting heat creep. I have no idea what else I can do to try to fix it, though. I’ll try again tomorrow.