Use an x-acto knife or a $5 PTFE cutter for best results.
Comment on [Troubleshooting] Cannot fix a clogging issue.
SzethFriendOfNimi@lemmy.world 10 months agoMaybe recut the Bowden tube to make sure it’s not at an angle?
And then loosen the nozzle, push the tube all the way in and use the retaining clip, then tighten the nozzle into the heartbreak while it’s hot.
nezbyte@lemmy.world 10 months ago
SzethFriendOfNimi@lemmy.world 10 months ago
And cut it with filament inside to keep it from deforming the cut too.
papalonian@lemmy.world 10 months ago
It’s an all metal hot end, so the Bowden tube does not run down to the nozzle.