Another way to think of it is this: Volts are like water pressure (potential energy) Amperage is like the flow rate of water Ohms (resistance) is like how hard it is to push water from high pressure to low pressure Watts are like the volume of water (a unit of energy)

A big hose has low resistance, water can move freely A coffee straw has large resistance, it’s hard to pull and push water thru it

A river has very low water pressure, and the speed of the water can vary, so volume of water moving can be huge so the flow rate of water can be huge as well. A pressure washer might have very high pressure, but use as much water as a kitchen faucet. Certain applications need high pressure, some need low pressure. A car battery is like a river, low pressure (typically 12volts) but move a lot of amps (cold cranking amps of up to 500-600 ish usually), and a wall outlet by comparison is like a pressure washer with 120v, 15A (in the US). A fridge won’t play nice on 12v, it needs 120v. It might need 400 watts which a car battery can do but it cares about how it can get that by requiring higher potential.

A watt, W=VA, can be thought of as asking how much water is there? 1 minute under a sink verse 1 minute in front a fire hose has two very very different amounts of water.

A watt hour, which most people are familiar with in the US for billing on their utilities, is like asking how many cups of water an hour. A light bulb needs a fraction of a kilowatt hour, a drier needs multiple kilowatt hours, but might only run for 30 minutes.

This idea gets a little tricky and falls apart at its edges but as a general idea should hold up for most peoples understanding of electrical stuff unless you work with it daily like an electrical engineer, electrician or something similar. For sanity sake I’m not going to try to apply this to AC verse DC, I don’t have a good analogy for that

Obligatory mobile formatting heads-up and what not and I’m not caffeinated so meh