Comment on Well there's your problem
jimmydoreisalefty@lemmy.world 6 months ago
Awesome, you found the problem!
Any before and after pictures of builds, and of problem area?
Thanks for sharing!
Comment on Well there's your problem
jimmydoreisalefty@lemmy.world 6 months ago
Awesome, you found the problem!
Any before and after pictures of builds, and of problem area?
Thanks for sharing!
IMALlama@lemmy.world 6 months ago
Thanks!
Are you looking for prints that were of varrying degreea of quality, the printer itself (it’s a Voron 2.4 so there’s a decent build behind it), or what the hot end should look like when properly assembled?
jimmydoreisalefty@lemmy.world 6 months ago
Yes, before and after pictures of quality prints, if possible!
While also showing an updated picture of what you posted!
IMALlama@lemmy.world 6 months ago
Here are two before and one after. Lower left = top layer over extrusion, but the bottom was fine. Lower right = that’s only 2-3 layers in total, but since it was way too close to the bed it was rippling like crazy. The cube = hot off the press and looking pretty good.
Image
I didn’t take any fixed photos of the hot end, but this page has a number of pictures showing what it should look like (look at the three screws if you didn’t see them sticking out in my earlier picture).
jimmydoreisalefty@lemmy.world 6 months ago
Wow, great picture!
Thanks for the link, I did a quick comparsion of your pic and the one in the link:
Image
Thank you for taking the time to show us your print problems and explaining!