Comment on Why do my TPU prints look like this?
MrSlicer@lemmy.world 11 months agoNot necessarily. If you don’t hear any sizzle like little pops when extruding you are fine.
Also watch out for retraction amount and speed. You don’t want more than 1 or 2 mm of retraction at 15mm/s and try to only print that slow as well.
rikudou@lemmings.world 11 months ago
Do these seam reasonable?
Image
MrSlicer@lemmy.world 11 months ago
I don’t go above 20 mm/s for any print setting with tpu.
TwanHE@lemmy.world 11 months ago
All depends on your extruder. A decent extruder should have no problems with 200mm/s+