Comment on Why do my TPU prints look like this?

• MrSlicer@lemmy.world ⁨1⁩ ⁨year⁩ ago

  Not necessarily. If you don’t hear any sizzle like little pops when extruding you are fine.

  Also watch out for retraction amount and speed. You don’t want more than 1 or 2 mm of retraction at 15mm/s and try to only print that slow as well.

  source

  • rikudou@lemmings.world ⁨1⁩ ⁨year⁩ ago

    Do these seam reasonable?

    Image

    source

    • MrSlicer@lemmy.world ⁨1⁩ ⁨year⁩ ago

      I don’t go above 20 mm/s for any print setting with tpu.

      source

      • TwanHE@lemmy.world ⁨1⁩ ⁨year⁩ ago

        All depends on your extruder. A decent extruder should have no problems with 200mm/s+

        source