Comment on Why do my TPU prints look like this?

MrSlicer@lemmy.world ⁨1⁩ ⁨year⁩ ago

• rikudou@lemmings.world ⁨1⁩ ⁨year⁩ ago

  I did. So this might be still too much moisture?

  source

  • MrSlicer@lemmy.world ⁨1⁩ ⁨year⁩ ago

    Not necessarily. If you don’t hear any sizzle like little pops when extruding you are fine.

    Also watch out for retraction amount and speed. You don’t want more than 1 or 2 mm of retraction at 15mm/s and try to only print that slow as well.

    source

    • rikudou@lemmings.world ⁨1⁩ ⁨year⁩ ago

      Do these seam reasonable?

      Image

      source

      • MrSlicer@lemmy.world ⁨1⁩ ⁨year⁩ ago

        I don’t go above 20 mm/s for any print setting with tpu.

        source

        • -> View More Comments