Comment on Major issues with klipper and bed levelling

• Grippler@feddit.dk ⁨9⁩ ⁨months⁩ ago

  Sure

  [bed_mesh] speed: 150 horizontal_move_z: 5 mesh_min: 25, 17 mesh_max: 220, 200 algorithm: bicubic bicubic_tension: 0.5 probe_count: 6, 6

  source

  • morbidcactus@lemmy.ca ⁨9⁩ ⁨months⁩ ago

    What type of probe and what’s the config on it?

    pin: PC14
    x_offset: 23
    y_offset: 5
    #z_offset: 0.10
    speed: 20.0
    samples: 5 
    samples_result: average
    sample_retract_dist: 1.0
    #samples_tolerance: 0.010
    #samples_tolerance_retries: 10 
      
    Is what I've got my pinda probe configured with, was playing around with sample tolerances like I have on my printer with a tap probe but I just found the inductive probe has a lot of variation, I added more samples to hopefully average out that error. 
    
    ```[bed_mesh]
    algorithm: bicubic
    fade_start: 0.6
    fade_end: 10.0
    bicubic_tension: 0.2
    faulty_region_1_max: 120.0, 74.0 
    faulty_region_1_min: 85.0, 45.0 # 103,69
    faulty_region_2_max: 125.0, 165
    faulty_region_2_min: 70, 110 # 103, 137
    horizontal_move_z: 2
    mesh_max: 228,210
    mesh_min: 24, 6
    mesh_pps: 2, 2
    probe_count: 5,5
    speed: 200
     
    Is my mesh setup, based on a [mk3s klipper config](https://github.com/dz0ny/klipper-prusa-mk3s). Meshes look a little odd but I ran some bed level prints fine and just ran a full plate of abs with pretty consistent 1st layer.
    

    source