Comment on Troubleshooting a fully custom build
Shadow@lemmy.ca 10 months agoYeah this is a good call to check. Can you even just squirt filament into the air consistently?
Comment on Troubleshooting a fully custom build
Shadow@lemmy.ca 10 months agoYeah this is a good call to check. Can you even just squirt filament into the air consistently?
franzfurdinand@lemmy.world 10 months ago
Yep! It actually extrudes just fine. I’m starting to wonder if maybe my z axis e-steps are just slightly off and it’s enough to compound over the course of the print. It seems to hit a certain spot and start grinding itself into the print, which suggests that it might not be moving up enough per layer.
IMALlama@lemmy.world 10 months ago
It looks like you’re under-extruding and/or clogging. If you can get filament through your nozzle in air, but not while printing, I wonder if you have enough tension on your filament? Extruder emperature variation as you move around might be another possibility. Not moving correctly in z would cause your parts to mushroom and is easy enough to check by homing, moving the nozzle to say z10, and then measuring the gap.
Good luck!