Comment on too hot? too cold?

• UniversalFlamingo@lemmy.world ⁨9⁩ ⁨months⁩ ago

  I printed a tower a few days ago and it looks good anywhere from 200 to 215. I’m going to keep trying though.

  source

  • infinitevalence@discuss.online ⁨9⁩ ⁨months⁩ ago

    You should also check your z offset and make sure that you’re not too close to the bed it’s possible that your nozzle is dragging because you’re less than .2 mm.

    source
  • rambos@lemm.ee ⁨9⁩ ⁨months⁩ ago

    Then your temp is fine i would say. For flat print with only few layers higher temp shouldnt be an issue.

    Im bit confused honestly, dont know what you changed there. First pic looks like overextruding and 2nd pic as underextruding. Keep in mind that if your nozzle is too far from bed and you overextrude first layer can look great, but on next layers it will show up (thats how 1st pic looks to me)

    source