Comment on too hot? too cold?
infinitevalence@discuss.online 9 months ago
i dont see an image?
what type of Inland PLA, silk generally requires higher temps but some of the more standard ones print well at 180-190.
Comment on too hot? too cold?
infinitevalence@discuss.online 9 months ago
i dont see an image?
what type of Inland PLA, silk generally requires higher temps but some of the more standard ones print well at 180-190.
UniversalFlamingo@lemmy.world 9 months ago
Weird. I couldn’t post the original pic but a screenshot of it seems to work.
The spool doesn’t say “silk” but the sticker does say print temp 215-230: www.amazon.com/…/B084RDMG7C/ I’ll give that a shot & see if it looks any better.
infinitevalence@discuss.online 9 months ago
www.printables.com/model/…/files
I would suggest running the PLA temp tower and then you can optimize for that specific reel of filament.
UniversalFlamingo@lemmy.world 9 months ago
I printed a tower a few days ago and it looks good anywhere from 200 to 215. I’m going to keep trying though.
infinitevalence@discuss.online 9 months ago
You should also check your z offset and make sure that you’re not too close to the bed it’s possible that your nozzle is dragging because you’re less than .2 mm.
rambos@lemm.ee 9 months ago
Then your temp is fine i would say. For flat print with only few layers higher temp shouldnt be an issue.
Im bit confused honestly, dont know what you changed there. First pic looks like overextruding and 2nd pic as underextruding. Keep in mind that if your nozzle is too far from bed and you overextrude first layer can look great, but on next layers it will show up (thats how 1st pic looks to me)