Comment on Underextrusion at the start of first layer infill with Cura 5.2.2
DreadPotato@sopuli.xyz 8 months ago
Maybe some sort of Z-lift is enabled for transport moves and not printing moves?
Comment on Underextrusion at the start of first layer infill with Cura 5.2.2
DreadPotato@sopuli.xyz 8 months ago
Maybe some sort of Z-lift is enabled for transport moves and not printing moves?
Hunex@lemmy.world 8 months ago
Z hop is disabled, and there is no retraction based on the gcode and I was watching during the whole print as well. I will try printing with retraction disabled tho.
DreadPotato@sopuli.xyz 8 months ago
Is there a reason you’re not just using orusa slicer since that works and cura doesn’t?
Hunex@lemmy.world 8 months ago
I tried using it on some prints but for some reason the parts were warping and the dimensions were off. With Cura it was perfect. I have to note that I’ve been always using Cura and just tried Prusa, so I’m sure if I tuned every value it would be just as great, but it would be a big time investment.