It’s running a version of marlin 2.xx, but it’s a build made by anycubic themselves, so I’m not sure about the specific version it’s based on or the detailed config.
Its an issue since my custom g-code to wipe me nozzle before a print (which has worked just fine BTW) now tries to wipe the nozzle on the bed area, but the Z-setpoint is 1mm below bed surface (the Z-position of the wiping-pad at the back), so it kind of destroys both nozzle and bed.
DreadPotato@sopuli.xyz 10 months ago
It’s running a version of marlin 2.xx, but it’s a build made by anycubic themselves, so I’m not sure about the specific version it’s based on or the detailed config.
jaykay@lemmy.zip 10 months ago
I was hoping you’re on Klipper 😅 not sure what to do honestly, but idk if it’s worth troubling yourself with 5mm haha
DreadPotato@sopuli.xyz 10 months ago
Turns out SW end-stops got enabled by a FW update i did. I just disabled them, and now I can move beyond the bed size.
jaykay@lemmy.zip 10 months ago
Good to hear :)
DreadPotato@sopuli.xyz 10 months ago
Its an issue since my custom g-code to wipe me nozzle before a print (which has worked just fine BTW) now tries to wipe the nozzle on the bed area, but the Z-setpoint is 1mm below bed surface (the Z-position of the wiping-pad at the back), so it kind of destroys both nozzle and bed.