Comment

Here is another picture showing the insulation and how it connects to the grate that I showed in one of the original pictures. I don’t see any rot or anything like that but it’s also never had heat running in it before, which I assume would make things worse. The fact it leads straight to where the insulation with no gap or anything feels all kinds of wrong… Would something like baffles be helpful? I could potentially push them behind the insulation to open a gap between the roof deck and insulation.

Image

source

Sort:hotnew top

Wwwbdd@lemmy.world ⁨9⁩ ⁨months⁩ ago
Baffles will do it If you’re willing to do the work, and based on the fact you’re already ripping holes in walls, I guess you might be

Tear out the wall, baffles against the roof deck in each cavity. At the ridge you’ll need ventilation for the air to escape, ridge venting or otherwise. I’d add 2x3s or 2x4s running horizontally on 16s. You could also just lay them all overtop the existing rafters but if you’ve gone to this point you might as well do it horizontal to avoid the thermal bridging. Laying over top is easier to insulate, up to you. Next insulate, then vapor barrier. I’d use acoustic sealant at the perimeter of your vapor barrier, it’s sticky messy stuff but will help immensely with warm air leakage

source
- Insight@lemmy.world ⁨9⁩ ⁨months⁩ ago
  I had to take down a horrible staircase one of the previous owners stuck in which was put in seemingly before sheet rock so the sheet rock was fitted to the stairs which lead to holes in the sheet rock. The one I took the picture out of is part of that.
  
  What do you mean by horizontal and avoiding “thermal bridging” if you have any diagram that could possibly help I would appreciate it. I figure if I am going to fix up the structure I might as well try to fix any moisture issues and sheet rock isn’t too expensive… Most likely it will be a longer project that I slowly work on the next couple months.
  
  source
  - Wwwbdd@lemmy.world ⁨9⁩ ⁨months⁩ ago
    Image
    
    That’s what I mean by running some framing horizontally, put a new set of studs horizontally over top the existing studs. Thermal bridging is the ease that the cold moves through your framing. On frosty mornings you can sometimes see where the trusses are on a roof up because the cold moves more easily through the stud vs the insulation. You have 2 options once you install the baffles, either nail a 2x3 directly over the existing rafters to make the wall 1.5" deeper giving room for insulation + baffle, or run the new framing horizontal. Horizontal makes insulating much harder but it gives a bit of a thermal break from the interior drywall to the rafter touching the exterior roof deck.
    
    source