Comment on Backyard structure fix up
Wwwbdd@lemmy.world 11 months agoFor example, would something like taking the sheetrock down (see what is behind it) and possibly add some vapor barriers with a thin airgap between the roof and the conditioned space. I guess similar to firring strips?
That’s pretty much it. If you’re willing to go to the trouble, remove the wood soffit and replace it with vented, put in a wood fascia, tear out the ceiling from the inside, create an airspace that goes right up to the ridge and vents out the top, then rebuild the ceiling
You want it to go from outside-in: roof deck, ventilation, insulation, vapor barrier, interior finish. How much space you’re willing it lose vs how much insulation and air space is up to you. Again, my experience is building in cold climates, not wet ones
Insight@lemmy.world 11 months ago
Here is another picture showing the insulation and how it connects to the grate that I showed in one of the original pictures. I don’t see any rot or anything like that but it’s also never had heat running in it before, which I assume would make things worse. The fact it leads straight to where the insulation with no gap or anything feels all kinds of wrong… Would something like baffles be helpful? I could potentially push them behind the insulation to open a gap between the roof deck and insulation.
Image
Wwwbdd@lemmy.world 11 months ago
Baffles will do it If you’re willing to do the work, and based on the fact you’re already ripping holes in walls, I guess you might be
Tear out the wall, baffles against the roof deck in each cavity. At the ridge you’ll need ventilation for the air to escape, ridge venting or otherwise. I’d add 2x3s or 2x4s running horizontally on 16s. You could also just lay them all overtop the existing rafters but if you’ve gone to this point you might as well do it horizontal to avoid the thermal bridging. Laying over top is easier to insulate, up to you. Next insulate, then vapor barrier. I’d use acoustic sealant at the perimeter of your vapor barrier, it’s sticky messy stuff but will help immensely with warm air leakage
Insight@lemmy.world 11 months ago
I had to take down a horrible staircase one of the previous owners stuck in which was put in seemingly before sheet rock so the sheet rock was fitted to the stairs which lead to holes in the sheet rock. The one I took the picture out of is part of that.
What do you mean by horizontal and avoiding “thermal bridging” if you have any diagram that could possibly help I would appreciate it. I figure if I am going to fix up the structure I might as well try to fix any moisture issues and sheet rock isn’t too expensive… Most likely it will be a longer project that I slowly work on the next couple months.
Wwwbdd@lemmy.world 11 months ago
Image
That’s what I mean by running some framing horizontally, put a new set of studs horizontally over top the existing studs. Thermal bridging is the ease that the cold moves through your framing. On frosty mornings you can sometimes see where the trusses are on a roof up because the cold moves more easily through the stud vs the insulation. You have 2 options once you install the baffles, either nail a 2x3 directly over the existing rafters to make the wall 1.5" deeper giving room for insulation + baffle, or run the new framing horizontal. Horizontal makes insulating much harder but it gives a bit of a thermal break from the interior drywall to the rafter touching the exterior roof deck.