Comment on Issues with layer adhesion (i think)

• rambos@lemmy.world ⁨1⁩ ⁨year⁩ ago

  -4c is extreemly cold, get thermometer inside of enclosure and leave your heatbed on until it reaches 10-15C before you start printing. Even better get enclosure heater. Id also bump nozzle temp to the highest marked on your spool.

  source
• FuglyDuck@lemmy.world ⁨1⁩ ⁨year⁩ ago

  Crossing my fingers for yah.

  source

  • ArtVandelay@lemmy.world ⁨1⁩ ⁨year⁩ ago

    Ok, so the print came out great. Unfortunately, it was a print without top and bottom layers and honeycomb infill of only about 12%, and I accidentally squished it getting it off that extremely cold bed this morning lol. To the immediate problem I posted above though, I think it was definitely a clogged nozzle which you helped fix, and the layer adhesion is probably due to enclosure temperature being too low when I start the print. I will correct both of those things, and then go watch YouTube on how to remove a print from a cold bed haha

    source

    • FuglyDuck@lemmy.world ⁨1⁩ ⁨year⁩ ago

      So, one of the tricks for really stuck on prints, at least for glass beds, is to put it in the freezer and then hold the build plate vertically and tap it on something hard. (Firm, but not so hard it breaks or anything.) my experience in the past is, with some exceptions… it goes in the freezer and pops right off. if bed adhesion is too good, you can try adjusting zoffset to print a little higher.

      you can speed warming up the enclosure with a hairdryer or heat gun.

      source