It’s actually a bit crazy - and very impressive - that the cable I use to tickle-charge my phone at 15W could also be used to connect four 4K screens, an external GPU, multiple 10GBe network adapters all while providing well over 200W of power… if my phone supported and of that, that is.
Comment on Ifixit gives fairphone 5 a 10/10 on repairability and maintanence
turmacar@lemmy.world 11 months agoIf you wanted them just for charging it would be fine. Barrel jacks are still pretty ubiquitous.
If you want them to also be data they get less great. They make 3.5mm/etc jacks with 3 “pins” and I assume more. But every time you’re inserting/removing the cable it’s rubbing past the insulators separating the contacts. Their failure rate is higher than something like USB-C where the 24 contacts are being pushed together instead of brushing past each other. It would suck if you put in your USB-barrel and one of the contacts broke/bent.
rmuk@feddit.uk 11 months ago
Tlaloc_Temporal@lemmy.ca 11 months ago
That’s just the USB-C standard, to get 200W and 4k video you need the fancy shielded high-gauge cables.
Petter1@lemm.ee 10 months ago
Well for only 4k, a relatively normal USB-C cable is enough, the fancy cables are for 20 and 40 Gbit/s which is only needed if you gl crazy with your FPS | Hz (more than 60Hz | FPS
jasondj@ttrpg.network 11 months ago
Typical stereo headphones have 3 pins. Left, right, common ground. Tip, ring, and sleeve (not sure if the conductor order).
4-conductors used to be common for portable camcorders and early digital cameras. They’d put our composite a/v (extra conductor for video/yellow, still a shared ground). Tip, R1, R2, sleeve.
I’ve seen USB 2.0 (or perhaps 1.x) done over a 4-pin 3.5. And I’ve seen RS232 over 3.5 a number of times too (used to be common in ham radio in the 90s/early naughts).
turmacar@lemmy.world 11 months ago
The video ones are what I was thinking of. Fair enough that I forgot to count ground.