Comment

Comment on What happens of you use the gas from the exhaust pipe to inflate a tire?

bestusername@aussie.zone ⁨11⁩ ⁨months⁩ ago

There’s going to be a limit to how much pressure before stalling and/or damaging the engine, but it would inflate, and as the gases cooled, it would deflate somewhat.

Exhaust jacks are used in 4x4 recovery, so an engine can lift a car, but they seem pretty limited and dangerous and over only seen one used once in my ~25yrs off road.

source

Sort:hotnew top

0Xero0@lemmy.world ⁨11⁩ ⁨months⁩ ago
Okay hear me out, I know this is funking stupid but what if: We only use a portion of the exhaust and make some sort of system that can feed the gas to when wheels are spinning and monitor the pressure at the same time, then add a lining on the inside of the tires to protect the rubber.

source
- aelwero@lemmy.world ⁨11⁩ ⁨months⁩ ago
  These systems exist already, they just use a belt driven air compressor because it’s ridiculously more practical/efficient.
  
  source
- the_sisko@startrek.website ⁨11⁩ ⁨months⁩ ago
  I have an air compressor which is powered by the 12V DC outlet in a car. They are quite cost effective and easy to buy. I use it all the time to refill my tires. Much better than some odd exhaust pressure solution.
  
  source
- threelonmusketeers@sh.itjust.works ⁨11⁩ ⁨months⁩ ago
  
  and make some sort of system that can feed the gas to when wheels are spinning
  
  Rotating seals are always a pain in the ass.
  
  source
  - squaresinger@feddit.de ⁨11⁩ ⁨months⁩ ago
    Yeah, these guys suck.
    
    Image
    
    source
XeroxCool@lemmy.world ⁨11⁩ ⁨months⁩ ago

so an engine can lift a car

Force = pressure x area

It’s not that big of a feat. Using the very low estimate of 2.5psi from another comment about exhaust pressure, that means it can sustain 2.5 pounds(force) per square inch. To lift half a 5000lb suv the force needed would be 2500lbs. Rearrange the equation to [area = force/pressure] and it becomes [area = 2500lbs/2.5 lbs per square inch] so 1,000 square inches. Divide by 144square inches per square foot (12x12) and you get 6.94 square feet gives you 2500lbs of force from 2.5psi. Then to find that area from a circle, divide by pi and square root the result (rearranging area=pi*r^2 ) and you find that 2.5psi will lift the side of an SUV with a little less than a 3 foot diameter circle. That’s about the size of the lift bags I’ve seen.

And all that while I’m thinking 2.5psi sounds low. Regardless, I doubt an exhaust system would handle anything close to tire pressure before popping off fittings. Plus mufflers have weep holes and fittings tend to leak anyway. They rely on the direction and speed of exhaust gas a fair amount.

source