Comment on Constantly Adjusting Z Height Offset
neal33@lemm.ee 1 year ago
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
Comment on Constantly Adjusting Z Height Offset
neal33@lemm.ee 1 year ago
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
OZFive@lemmy.world 1 year ago
Overture PLA
neal33@lemm.ee 1 year ago
Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.
OZFive@lemmy.world 1 year ago
It is secure. Not a wiggle or jiggle to it.