neal33
@neal33@lemm.ee
- Comment on Issue with Klipper on Creality Ender 3 S1 Plus 11 months ago:
I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520If that is not the case for you, try to add some more details. Do you have the config file correct?
- Comment on I made another Hockey Team Keychain 11 months ago:
.05 on my ender 3 s1 sounds perfect based on the tolerance tests I’ve run. Thanks!
- Comment on I made another Hockey Team Keychain 11 months ago:
Thats a very fair point. I’ve done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!
- Comment on I made another Hockey Team Keychain 11 months ago:
Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn’t sure how much to add.
- Comment on Constantly Adjusting Z Height Offset 11 months ago:
Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.
- Comment on Constantly Adjusting Z Height Offset 11 months ago:
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
- Comment on Klipperized my Sv06 - 10/10 do recommend 1 year ago:
Similar results with my Ender 3 S1. Highly recommend!
- Comment on "Wood" staining, sanding, and clear coating? 1 year ago:
How long did you leave the stain on before wiping it?
- Comment on lemm.ee plans for mitigating image upload abuse 1 year ago:
The same can be said about Lemmy.
- Comment on Advice/Opinions about first printer... 1 year ago:
I have the S1 (non pro version). I purchased it around a month ago and have been loving it! Sure, it requires a little bit of tinkering, but ultimately if I have the z-offset correct for the first layer, it prints great. I imagine there are quicker printers out there, and ones that have more features. But for an entry printer, I cant complain. If you have any questions, feel free to reach out!
- Comment on Printed some wall mounts for my and my kids skateboards 1 year ago:
I appreciate the tips - I printed using the same settings you used and it turned out great! Ill get it mounted to the wall later today.
- Comment on Printed some wall mounts for my and my kids skateboards 1 year ago:
Thanks for sharing the files. I just found my skateboard from when I was younger and wanted a way to display it!