It looks like you’re replying to the thread vs individual comments. I would have seen your reply faster the other way around :(

FDM prints will be stronger and don’t require any chemical post-processing. They will require mechanical post processing (filling, sanding) if you want smooth features, but depending on what you intend to use the part for this might not be necessary. Some filaments, like ABS and ASA require some caution while printing (they release VOCs) and some filaments can absorb water while they’re out in the open, causing a decrease in print quality. If you stick to PLA and/or go through spools reasonably quickly it won’t be an issue. I print mainly PETG and while I don’t dry my spools and store them out in the open I don’t really have any issues with older spools.

SLA prints can have much smaller features, but require post processing (rinse and cure). SLA printers also tend to have smaller build volumes. There’s also the whole having to deal with unused resin thing and the fact that you probably should collect waste products and dispose of them properly. But if you’re making minis or something like that you’re much better off with a SLA printer.

On the FDM printer, a cheap stocker printer with a big following (eg Ender) is usually a fine option. There will be a lot of support in terms of community and parts. I’ve been running a rebranded Wanhao I3 clone, which is essentially an earlier ender, for 5+ years without much modifications. Most cheap FDM printers are going to require some amount of fiddling to keep them going. You’re also likely to eventually modify them to alleviate some of the design decisions that enabled their lower price points in the first place. That doesn’t mean you shouldn’t buy a cheap FDM printer if you’re on a tight budget, just know what you’re getting into.