Awesome, glad to hear it!

When you’re ready to try printing again I agree with the suggestions to:

• lower the bed temp to ~60c
• avoid using glue sticks or similar since it shouldn’t be necessary with PLA, and will just add another variable
• keep working through first layer print tests

I’m surprised you’re having adhesion problems with a PEI build plate. When I swapped to PEI it was like magic; filament effortlessly sticks and finished prints pop off from a gentle flex. There isn’t like a plastic shipping cover on it or something is there?

Anyway, good luck with the rest of your troubleshooting – I’m sure you’ll eventually get it dialed in :)