I’ll give this a shot, I was under the impression that you start with them as uncompressed as possible
Comment on Why am I having to level my Ender 3 s1 after every print?
Nanomerce@lemmy.world 11 months ago
have you made sure your adjustment knobs are as tight as possible?
I found that if I tightened all my knobs to max I could, then leveled by loosening some and adjusting the z offset, it would stay there for much longer.
GingeyBook@lemm.ee 11 months ago
AnarchoSnowPlow@midwest.social 11 months ago
Especially with those rubber-ish things. They seem to have a lot more expansion and contraction than the higher end springs.